Side stand sensor E-Chopper for Star-Biker 6.0s Luqi HL6.0 limit switch
25 / 45 / 70 km/h · Nur für Chopper 6.0s (Luqi HL6.0) · Garantie bleibt erhalten
Safe starting – only when the side stand is folded in. With the original limit switch for the side stand, you ensure that your Star-Biker Chopper 6.0s (also known as Luqi HL6.0s) can only start when the stand is correctly folded in. This sensor reliably detects the position of the side stand and, if necessary, interrupts the power supply to the motor. This prevents accidental starting with the stand extended – a crucial safety factor for you and other road users.
Key Technical Data
Your Advantages at a Glance
- Accident Prevention: Prevents dangerous levering of the vehicle in left turns due to a forgotten stand.
- High-Quality Workmanship: Robustly built and splash-proof for permanently reliable use in all weather conditions.
- Exact Fit: Specially developed for the frame mounting of the Star-Biker Chopper 6.0s / Luqi HL6.0s.
- Easy Installation: Quick replacement as an original spare part in case of wear or defect.
- Smooth Communication: Reports the stand status to the control unit (controller) of your e-chopper without delay.
- Scope of Delivery: 1× side stand limit switch including connection cable.
Vehicle Compatibility
This limit switch is the precisely fitting original spare part for the following models:
- Star-Biker Chopper 6.0s / 6.0s Premium
- Luqi HL6.0 / HL6.0s
- Luqi HL3.0
Expert Tip
Maintenance & Troubleshooting: Due to its design, the switch is located close to the ground, exposing it to dirt and splash water. If your e-chopper no longer starts despite a full battery and folded-in stand, a dirty or defective limit switch is often the cause. Clean the contact area regularly with some contact spray. When installing, make sure that the cable is laid in such a way that it cannot be pinched by the spring or the stand itself.
Frequently Asked Questions about the Product
Can I omit the switch?
We strongly advise against it. The side stand limit switch is an important safety feature. Driving off with the stand extended can lead to serious falls and is also relevant for the operating license of your vehicle.
Is the switch difficult to install?
No, installation is quite manageable for amateurs. It is usually fixed directly to the stand mount with a small screw and connected to the wiring harness via a plug connection.
Does this switch also fit the Star-Biker M1P?
This specific switch is optimized for the 6.0 series. For the M1P/M8S series, we offer different versions, as the frame mounts and plug connections may differ.